6
SWITCHING THE PROJECTOR ON AND OFF
WARNING: Connect the projector to a power supply with
a rated voltage within the following values: 110-240 V
AC, 50/60 Hz. It must be earthed (Fig. 12).
GRAPHICS RGB
HV
S-VIDEO
AUDIO OUT
HDMI 1
REMOTE
2
S-VIDEO
MENU
ESC
INPUT
1
5
4
0
I
HDMI 1
5
Power Switch:
Position I: On
Position 0: Off
Fused
Power Socket
Power Plug
In position I the projector will initialise itself (red and green LEDs
on) and then go into standby mode (red LED on) (Fig. 13).
SWITCHING ON FROM STANDBY
Press one of the keys on the remote control (Fig. 14):
- 0 to select the last input selected.
- 1-9 to directly select the corresponding input.
- With the keypad: press the ON/OFF button.
When the unit is switched on from standby the lamp
switches on; after a brief period of warming up, the im-
Preferably use a unit gain screen; high gain screens are
only effective when used with a small group of viewers
close to the screen’s centre. Prevent any lighting in the
room from shining directly onto the screen during projec-
tion as this will reduce the contrast of the projected image.
The screen should not be placed close to furniture and
other objects with reflecting surfaces, or to light-coloured
walls.
The manual lens shift adjustment allows the projected
image to be moved upwards vertically, in relation to the
centre of the screen; the maximum adjustment being
equal to half the height of the image. (Fig. 11b).
Image shift range: + 50% image.
Fig. 11a
Fig. 11b
Fig. 13
Fig. 12
Fig. 14
Fig. 10
S-VIDEO
AUDIO OUT
HDMI 1
REMOTE
2
S-VIDEO
MENU
ESC
1
5
4
HDMI 2
6
Comments to this Manuals