Sim2 HT5000 User Manual download pdf (Page 9)

XX is the hex representation of the value of Gamma.

Example: if the returned value is XX = 04 then Gamma is set to EN5.

Lamp Power

Action Command Response

Set 250 BE EF 1A 0C 00 1C 00 25 00 00 00 FA 00 00 00 00 00 00 00 OK 20 XX YY

Set 260 BE EF 1A 0C 00 14 9E 25 00 00 00 04 01 00 00 00 00 00 00 Error 15

Set 270 BE EF 1A 0C 00 6B 1E 25 00 00 00 0E 01 00 00 00 00 00 00

Set 280 BE EF 1A 0C 00 4D 9F 25 00 00 00 18 01 00 00 00 00 00 00

Set 290 BE EF 1A 0C 00 26 1C 25 00 00 00 22 01 00 00 00 00 00 00

Set 300 BE EF 1A 0C 00 AA 9D 25 00 00 00 2C 01 00 00 00 00 00 00

Get BE EF 1A 0C 00 E2 DE 25 00 01 00 00 00 00 00 00 00 00 00

YY XX is the hex representation of the value of Lamp Power.

Example: if the returned value is YYXX = 0118, then Lamp Power value is 280W.

Orientation

Action Command Response

Set Floor-Rear BE EF 1A 0C 00 D8 4E 35 00 00 00 00 00 00 00 00 00 00 00 OK 20 XX 00

Set Ceiling BE EF 1A 0C 00 14 8F 35 00 00 00 01 00 00 00 00 00 00 00 00 Floor-Rear

Set Floor BE EF 1A 0C 00 01 CF 35 00 00 00 02 00 00 00 00 00 00 00 01 Ceiling

Set Ceil-Rear BE EF 1A 0C 00 CD 0E 35 00 00 00 03 00 00 00 00 00 00 00 02 Floor

Get BE EF 1A 0C 00 1D 1F 35 00 01 00 00 00 00 00 00 00 00 00 03 Ceil-Rear

Error 15

XX is the hex representation of the value of Orientation.

Example: if the returned value is XX = 01, then Orientation is set to Ceiling.

2.3 Status Commands

Status Commands may be used to get the current value of the main projector parameters.

Status Commands

Parameter Command

Projector Status BE EF 10 0A 00 34 B7 01 01 00 01 01 15 01 00 00 02

Signal Status BE EF 10 0A 00 33 37 01 01 00 01 01 15 01 00 00 08

Lamp Status BE EF 10 0A 00 A9 36 01 01 00 01 01 15 01 00 01 10

Projector Status

If the unit is in Standby State the returned packet is:

06 3A 06 .. .. .. 00 SS 00

0 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Sim2 HT5000 User Manual Page 9